Which car battery terminal to connect first? “Positive first, then negative. When disconnecting the cables from the old battery, disconnect the negative first, then the positive. Connect the new battery in the reverse order, positive then negative.”. When you are replacing your car battery, It isn’t always easy to remember the order in
Dry the cable with compressed air. Slip the heat-shrink tubing over the cable and slide it down so it’s out of the way. Then insert the main cable and any smaller cables into the compression nut. Screw on the battery terminal and tighten until snug (Photo 3). Then slide the heat-shrink tubing over the connection and use a heat gun to shrink it.Title says it all, Installing when weather is warm makes this process much easier since the rubber on the cable ends tends to be softer unless old and brittl
Battery Replacement. Enter info for pricing. View Details. Jiffy Lube® recommends following manufacturer recommendations, where applicable, for maintenance schedules and service intervals. Not all services are offered at each Jiffy Lube® location. Please check with your local Jiffy Lube® service center for specific services offered.
Battery Terminal Brush. 10 mm Combination Wrench or Socket. Tools to remove battery bracket. Removing batteries that have the bracket on top. Removing batteries that have a side bracket. Dielectric Grease. To change the battery in your car, you must have a 10mm open-end wrench. The battery cables always use 10mm nuts. Is your car battery dead? Need a new car battery? Learn how to test if your car battery is bad and how to recharge a dead car battery. Also learn which car b Open the hood by pulling the hood release under the dashboard. Locate the battery in the engine bay. Disconnect the negative battery terminal. Disconnect the positive battery terminal. Remove the bracket that holds the battery in place. Remove the old battery and place the new battery in the battery tray. MXsQM.